Dragonfly Lattice Card with 3D Wings

Un proyecto de nuestro programa en directo Únete a Toni en su sesión de preguntas y respuestas y no te pierdas una oferta fantástica del programa, emitido el 7 feb 22 · 07/02/2022 · míralo desde 34:00

Make an elegant A5 card featuring a dragonfly with intricate lattice detailing. The design can be used as a simple embellishment or cut away and layered to create beautiful 3D wings that float above the card.

DESCARGAR ESTA GUÍA (PDF)

Paso a paso

1. Run the dragonfly lattice die through your cutting machine with cardstock to cut out the complete design. ▶ watch 34:15
2. Pop out the dragonfly pieces carefully from the die-cut cardstock. ▶ watch 34:45
3. Run the same die through again with a second piece of cardstock to create a duplicate dragonfly. ▶ watch 35:30
4. Carefully cut away the wings from one of the dragonfly pieces using scissors, leaving the body intact. ▶ watch 36:00
5. Glue the body of the first dragonfly flat onto your card base. ▶ watch 36:30
6. Layer the wings from the second dragonfly on top of the body using foam pads or 3D adhesive dots to create dimension. ▶ watch 37:00
7. Optional: add vellum or acetate behind the wings and embellish with sparkle for an ethereal effect. ▶ watch 37:45

Consejos del programa

• Cut the dragonfly twice to create two versions for layering the wings.
• Use foam pads or 3D adhesive to lift the wings away from the body for a floating effect.
• Add sparkle or glitter to the wings for extra dimension and shimmer.

Más de este programa

• Peacock Die-Cut Card with Layered Feathers
• Floral Frame Card with Paper Piecing
• Good Luck Card with Edge-Cut Detail

Redactado a partir del propio programa. Mira todos los tutoriales de nuestros programas · tutoriales gratis · míralo en directo en My Telly