LINK RAPIDI

info@howtocraftnetwork.com
Ancora più smart: acquista e guarda con l'app SBMSCARICA L'APPGuardaci in diretta sulla tua smart TVSCOPRI COMEScopri il nostro canale IPTV dedicato: vai su my-telly.comGUARDAAccumula punti fedeltà con ogni ordineSCOPRI DI PIÙ
Benvenuto su How to Craft Network
 
SBM SHOP
SEGUICI
REGALA AI TUOI AMICI 10 € DI SCONTO INVITA UN AMICO › SCOPRI MY-TELLY.COM › SIAMO DIVENTATI ANCORA PIÙ SMART SCARICA L'APP › CANALE PLURIPREMIATO SULLA TUA TV › ISCRIVITI AL CLUB PER RISPARMIARE ›
 

Gold Embossed Wax Seal Effect Mini Card

Un progetto dalla nostra diretta CREATE TOGETHER CLUB - Puntata 4 - Con Toni - In onda il 5 aprile 22 · 05/04/2022 · guardalo da 9:00

Create a luxurious mini card featuring a thick gold embossed panel with a stamped floral design that resembles a wax seal. The technique involves layering embossing powder multiple times and stamping into the warm emboss to create a dimensional, textured focal point.

Ti servirà

CREATE TOGETHER CLUB- Chapter One - 030921a fblCREATE TOGETHER CLUB- Chapter One - 030921a fblGUARDA

SCARICA QUESTA GUIDA (PDF)

Passo dopo passo

  1. Cut a piece of white cardstock to 5 by 4 inches for your mini card base. ▶ watch 9:00
  2. Cut a smaller piece of white card to sit in the centre with a nice outline border. ▶ watch 9:15
  3. Apply sticky ink pad to the centre card panel, pressing down firmly to get good coverage. ▶ watch 9:45
  4. Sprinkle gold embossing powder generously over the inked panel and tap off excess. ▶ watch 10:15
  5. Heat set the embossing powder with a heat gun until it melts and becomes shiny. ▶ watch 12:00
  6. Let the embossed panel cool for about two seconds, then quickly press your floral stamp into the warm emboss. ▶ watch 12:30
  7. If the stamp impression isn't clear enough, melt the embossing powder back down with your heat gun and try again. ▶ watch 13:00
  8. Apply another layer of sticky ink pad over the entire panel to build up thickness. ▶ watch 13:15
  9. Add more gold embossing powder and heat set again. ▶ watch 13:30
  10. Repeat the stamping process into the warm emboss, applying pressure to create a clear impression. ▶ watch 17:00
  11. Trim the embossed panel with a trimmer to neaten the edges and remove any imperfections. ▶ watch 23:30
  12. Mount the embossed panel onto a piece of white cardstock using glue and tape for secure adhesion. ▶ watch 24:30

Consigli dalla puntata

Altro da questa puntata

Scritto direttamente dalla puntata. Scopri tutte le guide delle nostre puntate · tutorial gratuiti · guarda in diretta su My Telly