Abstract Tulip Layered Stencil Card with Watercolour Spray Effect

Ein Projekt aus unserer Live-Show ANYTHING GOES - Sei bei Toni dabei – in der Show, in der du bestimmst, was passiert - Sendung vom 22. MÄRZ 23 · 22.03.2023 · ab 23:00 ansehen

A multi-layered stencil card using four coordinating abstract tulip stencils and a matching die. You create two versions: a clean, simple design with precise stencilling, and an artistic version with water spray to create a watercolour bleed effect around the design.

DIESE ANLEITUNG HERUNTERLADEN (PDF)

Schritt für Schritt

1. Remove all four numbered stencils from the packet and locate the heart registration marks in the corners of each stencil. ▶ watch 24:15
2. Place stencil number one on your card and line up the heart marks if you wish to use the registration system for alignment. ▶ watch 24:45
3. Ink through the four heart registration marks using your chosen ink colour to create a lineup guide on the card. ▶ watch 25:30
4. Ink through stencil one with pink ink, pressing firmly to transfer the colour through the stencil onto the card. ▶ watch 26:00
5. Align stencil two using the heart registration marks and ink through with the same pink colour, pressing harder for better coverage. ▶ watch 27:15
6. Swap to stencil three (the leaves layer) and line up the hearts again, then ink through using green ink. ▶ watch 28:00
7. Place stencil four (the final layer) on the card, align the hearts, and ink through using teal ink to complete the layered design. ▶ watch 28:45
8. For the watercolour version, repeat the stencilling process on a fresh card, inking each layer one at a time. ▶ watch 30:45
9. After inking stencil one, use a spray bottle to mist the inked area lightly with water, allowing the ink to bleed and create a watercolour effect. ▶ watch 32:00
10. Repeat the water spray technique after inking each subsequent stencil layer, spraying lightly to avoid over-saturating the card. ▶ watch 34:30
11. Once dry, add gold confetti ink splats across the design using a paintbrush to add extra sparkle and detail. ▶ watch 40:00
12. Use the coordinating die to cut out the layered design, then mount it onto a contrasting card base to complete the project. ▶ watch 42:15

Tipps aus der Show

• You only need to use the heart registration system once; after that, you can align the stencils by eye.
• Run the stencils under a hot tap at low pressure to clean them between colours—the ink slides off easily without needing a cloth.
• Do not over-spray with water when creating the watercolour effect, as too much water can cause the design to blur completely.

Mehr aus dieser Show

• Clean and Simple Stencilled Card with Sentiment

Direkt aus der Show aufgeschrieben. Alle Anleitungen aus unseren Shows ansehen · kostenlose Anleitungen · live auf My Telly ansehen