Dragonfly Lattice Card with 3D Wings

Run the dragonfly lattice die through your cutting machine with cardstock to cut out the complete design.

Pop out the dragonfly pieces carefully from the die-cut cardstock.

Run the same die through again with a second piece of cardstock to create a duplicate dragonfly.

Carefully cut away the wings from one of the dragonfly pieces using scissors, leaving the body intact.

Glue the body of the first dragonfly flat onto your card base.

Layer the wings from the second dragonfly on top of the body using foam pads or 3D adhesive dots to create dimension.

Optional: add vellum or acetate behind the wings and embellish with sparkle for an ethereal effect.