Gold Embossed Fireworks Shaker Card

Un progetto dalla nostra diretta RIVEDI Simon in MONDAY MADNESS, trasmessa dallo studio HTCN l'8 nov 21 · 08/11/2021 · guardalo da 25:15

A luxurious shaker card featuring an embossed fireworks background in rich gold relief, with a circular window filled with gold sequins. The design uses layered foam pads to create depth and movement, making it perfect for celebrations and special occasions.

Ti servirà

TAMPONE D'INCHIOSTRO VERSAFINE - ONYX BLACK - 300921cGUARDA

SCARICA QUESTA GUIDA (PDF)

Passo dopo passo

1. Glue a piece of gold glitter cardstock to your card base, centring it and leaving a white border on the sides. ▶ watch 26:15
2. Cut a backing panel from cardstock that is narrower than the gold layer, so you see a strip of gold down each side. ▶ watch 27:00
3. Stamp the large Fireworks background stamp onto the backing panel using embossing ink, ensuring full coverage. ▶ watch 27:15
4. Rub an anti-static bag over the stamped area to remove excess powder and ensure clean embossing. ▶ watch 28:00
5. Generously cover the entire stamped area with gold embossing powder. ▶ watch 29:15
6. Tap off excess powder back into the container, then use a heat gun to melt and set the embossing powder until it shines. ▶ watch 29:45
7. Die-cut a circular aperture in the centre of your embossed panel using a circle die. ▶ watch 31:45
8. Die-cut a gold ring from glitter cardstock using two circle dies of different sizes to create a frame. ▶ watch 34:30
9. Glue the gold ring around the edge of the circular aperture, keeping glue only on the gold to maintain neatness. ▶ watch 35:15
10. Attach an acetate panel to the back of the card over the circular hole using double-sided tape. ▶ watch 35:45
11. Apply foam pads around the entire edge of the aperture, pushing them close together so sequins cannot escape. ▶ watch 36:45
12. Apply a second layer of foam pads around the edge in the same way, then add support foam pads to the lower section. ▶ watch 38:30
13. Pour gold sequins into the aperture while it is still open, filling it generously. ▶ watch 40:15
14. Seal the shaker by pressing the pre-cut gold circle backing firmly over the foam pads and sequins. ▶ watch 40:45

Consigli dalla puntata

• Use double-sided foam pads in two layers to create enough depth for sequins to move freely.
• If you run out of foam pads, draft excluder tape can be used as an alternative, as it is sticky on one side.
• Make sure foam pads connect with no gaps between them, or sequins will fall out.

Altro da questa puntata

• Elephant Easel Card with Spray-Painted Stars
• Gold Embossed Elephant with Make-a-Wish Shaker Topper

Scritto direttamente dalla puntata. Scopri tutte le guide delle nostre puntate · tutorial gratuiti · guarda in diretta su My Telly