Partial Embossed Panel Card with Mount Board

Ein Projekt aus unserer Live-Show MONTAGS-PODCAST - Hol dir mit Toni Darroch die neuesten Updates und jede Menge Inspiration - Ausgestrahlt am 17. Juli 23 · 17.07.2023 · ab 23:30 ansehen

Create a card with selective embossing on only part of the design using mount board as a blocker. This technique gives you embossed texture on one section whilst keeping the rest flat, perfect for adding visual interest without overwhelming the whole card.

DIESE ANLEITUNG HERUNTERLADEN (PDF)

Schritt für Schritt

1. Cut your white cardstock to embossing folder size. ▶ watch 24:00
2. Place your cardstock into the embossing folder as if you were going to emboss the entire image. ▶ watch 24:15
3. Position a piece of mount board (approximately 2mm thick) over the area you want to remain flat, blocking the embossing in that section. ▶ watch 26:30
4. Insert the embossing folder with the cardstock and mount board into your die-cutting machine using the thin plate setting. ▶ watch 27:00
5. Run the folder through the machine, applying gentle pressure. ▶ watch 27:15
6. Remove the cardstock from the folder to reveal partial embossing on one side only. ▶ watch 27:45
7. Admire the embossed panel effect where the mount board blocked the embossing from occurring. ▶ watch 28:00

Tipps aus der Show

• You can cut the mount board into shapes like hearts or letters to create patterned partial embossing.
• Make sure the mount board is slightly smaller than your embossing folder to avoid harsh lines at the edges.
• If using a square embossing folder, cut your mount board to a slightly smaller square size to prevent edge marks.

Mehr aus dieser Show

• Metallic Swiped Embossed Card
• Ink-Blended Embossed Card with Gold Accents
• Black Pen Outlined Embossed Card with White Ink Highlight

Direkt aus der Show aufgeschrieben. Alle Anleitungen aus unseren Shows ansehen · kostenlose Anleitungen · live auf My Telly ansehen