Dragonfly Lattice Card with 3D Wings

Een project uit onze live-uitzending Kijk mee met Toni voor haar vragenuurtje en een fantastische showaanbieding, uitgezonden 7 feb 22 · 07/02/2022 · bekijk het vanaf 34:00

Make an elegant A5 card featuring a dragonfly with intricate lattice detailing. The design can be used as a simple embellishment or cut away and layered to create beautiful 3D wings that float above the card.

DIT STAPPENPLAN DOWNLOADEN (PDF)

Stap voor stap

1. Run the dragonfly lattice die through your cutting machine with cardstock to cut out the complete design. ▶ watch 34:15
2. Pop out the dragonfly pieces carefully from the die-cut cardstock. ▶ watch 34:45
3. Run the same die through again with a second piece of cardstock to create a duplicate dragonfly. ▶ watch 35:30
4. Carefully cut away the wings from one of the dragonfly pieces using scissors, leaving the body intact. ▶ watch 36:00
5. Glue the body of the first dragonfly flat onto your card base. ▶ watch 36:30
6. Layer the wings from the second dragonfly on top of the body using foam pads or 3D adhesive dots to create dimension. ▶ watch 37:00
7. Optional: add vellum or acetate behind the wings and embellish with sparkle for an ethereal effect. ▶ watch 37:45

Tips uit de show

• Cut the dragonfly twice to create two versions for layering the wings.
• Use foam pads or 3D adhesive to lift the wings away from the body for a floating effect.
• Add sparkle or glitter to the wings for extra dimension and shimmer.

Meer uit deze show

• Peacock Die-Cut Card with Layered Feathers
• Floral Frame Card with Paper Piecing
• Good Luck Card with Edge-Cut Detail

Uitgeschreven op basis van de show zelf. Bekijk alle stappenplannen uit onze uitzendingen · gratis stappenplannen · kijk live op My Telly