Layered Hellebore Flower Card with Embossed Details

Select a coloured paper from the hellebore collection. Note that the papers feature pre-printed shading and veining on both sides to create realistic flower petals.

Place the connected die set onto your die-cutting machine, ensuring the paper is positioned correctly with the printed side facing up. Store the dies back in their packaging when finished.

Run the die set through your die-cutting machine in one pass to cut all three flower sizes and the accompanying leaves simultaneously. Store the cut pieces back in the decant packaging to keep them organised.

Pop out all the cut pieces from the carrier sheet. Remove the flowers, leaves and other elements carefully, revealing the double-sided printed pieces ready for assembly.

Layer the three flower sizes together, starting with the largest at the bottom, then the medium, and finally the smallest on top. Use a small spot of glue in the centre to secure each layer.

Position the two green leaves beneath the layered flowers, angling them naturally to frame the bloom. Place one leaf on each side of the flower arrangement.

Take the small sprigly element and roll it tightly. Secure the rolled piece in the centre of the hellebore flower using glue to create a 3D centre detail.

Adhere the completed flower cluster to your card base. Position the pink-edged petals and leaves as desired to create your focal point arrangement.