Ghost Stamping Card with Vellum and Embossed Details

Place a piece of vellum in the centre of your card base, holding it in place with magnets.

Ink up your large border stamp with a sticky ink pad and stamp onto the vellum with firm, even pressure.

Remove the vellum carefully and set it aside, then re-ink the stamp and stamp the same design onto the card base in the same position.

Cover the stamped area on the vellum with white embossing powder, tapping off the excess.

Cover the stamped area on the card base with clear embossing powder, tapping off the excess.

Heat set the white powder on the vellum piece with a heat gun until fully melted.

Heat set the clear powder on the card base with a heat gun until fully melted.

From the white embossed cardstock, carefully cut out two large flower motifs from the stamped design.

Align and layer the vellum piece onto the card base, ensuring the designs line up seamlessly.

Adhere the vellum to the card base with a small amount of glue, being mindful not to use too much moisture as it can cause the vellum to cockle.

Attach the two cut-out flowers to the card using foam pads to add dimension.

Secure the vellum further by adding sequins or gems to hold it flat and add embellishment.